• Sealing and waterproofing glass to windows and door frames.
• Waterproofing and bonding of glass shower enclosures.

• Constructing and sealing smaller size glass aquariums.
• Creating waterproofing seal between glass and aquarium frames.

• For assembly and joining glass curtain walls in office spaces
• Sealing of store frontage for retail and commercial shops

• Sealing and bonding the glass to skylight frames
• Structural assembly glazing for skylights

• Waterproofing big glass exterior joins for commercial or domestic use.

This specialised sealer for glass was made to withstand the harshest NZ environments with extreme UV and temperature resistance (-40 C – 150 C)

With excellent adhesion strength and elasticity this waterproof seal will withstand high stress and severe conditions indoors and outdoors.

This RTV-1 sealant will prevent any mould growth which makes it superb for all glass applications in wet and humid areas.

Against cracking, pealing or crumbling under proper usage. We give the one of the longest and comprehensive guarantees in the industry

The base material need to be free of dust and grease or loose material. If needed clean up with a turpentine cloth and let it dry. Complete adhesion test before use and make sure good compatibility and viscosity of the sealant with base materials.

Cut off the top of the cartridge, position the threaded adaptor to the cartridge. Cut the threaded adaptor on an angle corresponding to the joint width. Place the cartridge into gun and inject the joint with the sealant. Apply sufficient pressure to the sealant to ensure good penetration and adhesion to the joint sides. The applied sealant should be smoothed immediately with a wet spatula or turpentine cloth to clean excess sealant. If you like to have a perfect joint finish use our STAERKS GENERAL PURPOSE MASKING TAPE by applying tape the full length of the joint on both sides leaving the desired gap you require. Place the cartridge into gun and inject the joint with the sealant. Apply sufficient pressure to the sealant to ensure good penetration and adhesion to the joint sides. The applied sealant should be smoothed immediately with a wet spatula or turpentine cloth to clean excess sealant. Remove the masking tape gently and if needed clean up the excess sealant one more time. Staerk Glass Acetoxy Silicone can’t be used for all marbles, granite, other alkalescent materials, and metals such as copper, brass, magnesium, Zinc or other electroplating metal materials.

Clean while uncured with a turpentine cloth. After hardening remove the silicone sealant mechanically or with a the silicone remover.